Tractor Talk Discussion Board |
Re: making a hydraulic valve spool
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Heat Houser on August 26, 2004 at 06:39:58 from (67.101.206.132):
In Reply to: making a hydraulic valve spool posted by markct on August 25, 2004 at 11:59:27:
I wouldn"t swap spools with another function unless the metering cuts on the spool lands are the same. The metering cuts allow you to "ease" into cylinder movement. If they are not the same, controlability may become an issue with jerkyness. The swapped spool may also bind in the new bore due to differences in fit up. I would make a new spool to replace your existing spool. What is your old spool made from? Does stainless have the same or better yield strength? The pressure working on the lands may fail the "necked down" portions of the spool by simply pushing them apart.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|