Tractor Talk Discussion Board |
Sandblasting Vs. Steam cleaning
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeb2N on July 19, 2004 at 12:37:07 from (65.40.234.137):
Hello; I have a tractor that has been stripped down to the engine, transmission, and rear axles. I need to clean it but I don't know which way to go. I have a small sand blaster (1/2" ID hose) but I can't rent an air compressor big enough to run it. I was also exploring the option of renting a steam pressure washer and steam cleaning all the old paint and grease off. If I sand blasted it, i'd have to carry the chassis to someone and have them do it by means of loading/unloading with a forklift which kinda scares me. I'm also worried about sand getting in the engine and transmission. I can't rent a true steam cleaner, but the guy says he'll rent me a high pressure washer that may or may not remove the paint so it sounds skeptical at best. Should I spray the whole thing down with oven cleaner and try my luck with the pressure washer (even though I have new gaskets all over the place) or do I run the risk of sandblasting and do it myself being extrememly careful? What say ye? Jeb
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|