Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: anyone running a sawmill o
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by sjh on July 12, 2004 at 06:08:01 from (66.153.13.189):
In Reply to: Re: Re: Re: Re: Re: anyone running a sawmill off a posted by Roger on July 12, 2004 at 04:59:17:
When you hammer a blade, you are putting tension in the steel. Every time the blade is hit with the hammer the more tension is put in the steel. IIRC the faster the blade speed the more tension you need on the outside of the blade. When the blade spins it causes it to expand. That is what hammering does. It controls expansion. When it heats up the blade expands more then you loose your tension. When the sawer is done with my blade it will be completely sraight edge flat. He told me a guy one time wanted his money back after hammering because it was not dished. He told the guy to go some place else. He only makes them flat. He is so busy it will take 2 months to gat my blade back. I do trust him with my life.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|