Tractor Talk Discussion Board |
Re: stuck bolt in aluminum
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Craig on May 10, 2004 at 19:27:21 from (24.159.60.36):
In Reply to: stuck bolt in aluminum posted by MARK R on May 10, 2004 at 13:53:49:
Once when I was a junior machinist I broke a long drill bit off inside a piece of aluminum that I had a lot of time into (expensive mistake to the boss). I struggled with getting the bit out for a while and gave up. An "old timer" told me to put the whole part in the freezer for a few hours. I thought he was kidding me, expected him to tell me to give the copper magnet a try next. Eventually he begged me into it. A few hours later I got the frozen part out of the freezer. When I was walking back to put it in the vise I happened to turn it over and the broken drill bit fell out onto the floor. Since then that advice has saved me a few times.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|