Tractor Talk Discussion Board |
Re: 11 ft wheel disc
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Evans on April 20, 2004 at 07:06:31 from (209.41.233.88):
In Reply to: 11 ft wheel disc posted by Scott on April 20, 2004 at 01:53:41:
I pull a 10' wheel disk behind a Farmall 460 (45 drawbar HP). This is my first season of running this combination, and the 10' disk is a great match for the 460. The tractor runs this disk comfortably with the disk wheels full up. Going up a grade will make the 460 bark, and I have to cheat a little by putting the wheels down. The trick to disking in my opinion is not in bragging rights--that is to say how wide a disk you can pull. Proper disking requires a decent amount of ground speed so that the coulters are not only cutting but are casting dirt, too. I'd much rather run in 3rd gear with a 10' disk than in 2nd with a 12' disk. More gets done on less fuel. I better match for your 800 is an 8' disk.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|