Tractor Talk Discussion Board |
Re: Re: Re: Re: What is a clutch finger?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray,IN on April 13, 2004 at 20:24:11 from (66.244.71.226):
In Reply to: Re: Re: Re: What is a clutch finger? posted by Bob on April 12, 2004 at 22:14:35:
Perhaps I,m wrong, but doesn't the pressure plate "fingers" sit in a relaxed position until the clutch pedal is depressed, then the "fingers" spring away as the throwout bearing presses against them? The outside of the throwout bearing does not turn when pressing against the "fingers", it just spins inside itself. This allows the "fingers" to spring individually (all at the same time). We've removed pressure plates with broken "fingers" from vehicles, including tractors, when the job was began to replace the clutch disc, and the vehicle was driven into the shop for repair. That's how it was in the 50's & 60's while I worked my way through school at my Uncle's shop.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|