Tractor Talk Discussion Board |
Re: CO-OP Grain Drill
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by nwb on March 26, 2004 at 08:08:46 from (63.155.180.97):
In Reply to: CO-OP Grain Drill posted by Beth on March 26, 2004 at 05:54:51:
There are two types of drills, force feed and double run. John Deere is force feed and most grass seeders on drills are force feed. FF drills have one seed rotor per row. Double run drills have two rotors per row. One rotor is for course grain and one is for small grains. Oliver drills were double run. Since you say yours has "two settings", I'm guessing it is a double run. If you can determine your type of drill, the settings from another brand of drill, of the same type, will be close enough to get you started. I've never found book settings to be very accurate. As for books or information check with your Agco dealer or try the Oliver Co-op board. Good Luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|