Tractor Talk Discussion Board |
Re: Things to do w/ my new IH 504
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Puller504 on March 22, 2004 at 04:08:57 from (199.35.100.144):
In Reply to: Things to do w/ my new IH 504 posted by Kirk Grau on March 19, 2004 at 06:17:15:
I have used 5 foot, 6 foot and 7 foot wide brushhogs on my IH504 over the years. Clipped the pasture on my Parent's dairy farm with the 5 footer, wasn't wide enough, took too much time. Borrowed a friend's 6 footer, this mower matched up with my 504 very well! The width of cut was close to the outside width of the rear tires. Used another friend's 7 foot wide Howse brushhog and had to put 1000 pounds of suitcase weights on the front bracket of the tractor just to get it on my trailer without back-tipping! Only did that once and went back to the lighter, more efficient 6 foot cut mower. I still use about 500 pounds of weights on the front end to stabilize the 504 on hills. Hope this helps! Don
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|