Tractor Talk Discussion Board |
Re: Re: Re: Brushoggin how tight stabilizer chains
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe on February 13, 2004 at 18:02:52 from (66.243.138.105):
In Reply to: Re: Re: Brushoggin how tight stabilizer chains posted by Dana on February 13, 2004 at 03:12:05:
On my Kubota, I like a real tight fit, but I'm going for a really smooth, flat cut. The tractor gets pushed on the turns a bit, but it is a light tractor. On my bigger tractor, mowing with little thought to the appearance of the final cut, I like a looser chain, the cut is a little less even, but I'm hauling butt, tearing up grass and weeds. If I bump a tree, I'm not tearing the bark off of it or getting pushed around. All my land is flat, so I don't have to worry about the mower getting crooked or going sideways on the side of a hill. Try it a couple of ways and see what you like the best. Hope this helps, Joe
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|