Tractor Talk Discussion Board |
Re: Re: Re: tractor usage
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greenbeanman on February 01, 2004 at 14:57:16 from (171.75.205.187):
In Reply to: Re: Re: tractor usage posted by Dr. H. T. Mowers on January 31, 2004 at 20:45:18:
I have a Hot Line" farm equipment guide that shows slightly different weights than the source Unimog used. 1720 with 2 wheel drive at 2,491. 1720 with 4 wheel drive at 2,711. 1720 with 4 wheel drive and shuttle shift trans at 2,690 Each with 23.5 PTO horsepower from a 91.3 cubic inch displacement engine. 950 with 2 wheel drive at 3,169. 950 with 4 wheel drive at 3,464. Each with a 27.3 horsepower from a 105 cubic inch displacement Yanmar engine. While I have a 1720 Ford, 4wd, SS trans, I certainly feel that the Deere is the better buy because of the equipment on it. Well, if you would ever use it that is. You might never want use of a backhoe and might simply want to sell it to someone who does. That would lessen your expense somewhat. Are the tractors conditions similar? Hours of useage? A backhoe might put a lot of additional stress on one if used hard. Do both have nearby dealers to get filters and parts and service from? How about ease of regular maintainence? Does one engine turn at higher engine RPMs than the other? Slower often means more torque because of a longer stroked engine. Do you feel the need for the additional horsepower of the Deere? With loader and backhoe the Deere will be a lot less maneuverable and will weigh considerable more. Is that a factor when mowing, or is your area open? Tires good on both tractors? In my opinion from my own experience, Ford used really crappy tires. I had lots of problems with them and tried to get Ford to replace them within the first 25 hours of usage. I got no where from my appeals with Ford. Otherwise the tractor has been great. Best wishes on making a wise choice.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|