Tractor Talk Discussion Board |
Re: 12 volt convert
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon H on September 16, 2003 at 17:01:47 from (69.26.16.172):
In Reply to: 12 volt convert posted by need help on September 16, 2003 at 15:16:50:
The #2 regulator wire goes to the BAT stud on the alternator rear,this is where the regulator senses system voltage. The #1 regulator wire goes to 12Volt power that is live only when the ignition switch is on. If you hook it to the same ignition switch terminal that feeds the coil,you need a Diode to block or small light bulb to restrict return flow of power to the ignition switch and coil. My personal preference is to use a small light bulb,as replacements are readily avalible and it serves as a charge indicator. Another method of feeding power to the #1 exciter wire is to use aan oil pressure switch wired to feed 12 volts to the alternator when the engine is running and has oil pressure. Have you converted the tractors to negative ground? This must be done to use an alternator.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|