Tractor Talk Discussion Board |
Re: Need some help designing a ROP for my oliver 5
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on August 18, 2003 at 20:28:54 from (142.177.105.39):
In Reply to: Need some help designing a ROP for my oliver 550 posted by Matt on August 18, 2003 at 07:28:45:
I don't want to rain on the parade here, but building a rollbar may not be the answer. In some areas, department of labor will not recognize a home built ROP, only factory approved. Here in Nova Scotia, I believe they will also approve something that is CWB certified. Approval would be a consideration if you are trying to meet regs or insurance etc. That said, if it is purely for your own safety, then over building is the way to go. 2x6x1/8 would be a minimum. 1/4 would be better. To use round pipe, you would need to depend on the tractor landing upside down with the ROP standing perpindicular, for the pipe to have any strength. Round pipe would likely just fold back. That's why rectangular steel is used...to take advantage of the cross section. One final note...use a seat belt, or just save your money. The ROP will do more harm than good, unless you're strapped in. Good luck. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|