Tractor Talk Discussion Board |
Re: Need some help designing a ROP for my oliver 5
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 26Red on August 18, 2003 at 11:45:54 from (170.92.1.104):
In Reply to: Need some help designing a ROP for my oliver 550 posted by Matt on August 18, 2003 at 07:28:45:
I would take a look at other tractors similar in size to your Oliver 550 that have a ROPS. Use at least 2x2x.188 wall tubing. Square is stronger than round tubing. Contact a local machine shop to help with the bending. Overbuilding will not hurt. Besure to mount the ROPS securely on the tractor. Some problems to note, on the letter series farmalls, the axle castings are not strong enough to survive an rollover with ROPS mounted on the axles alone. So tie your mounting points into several places on the tractor. You may find a 4 post design will be easier to mount.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|