Tractor Talk Discussion Board |
Re: 4020 pto noise
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brokenwrench on August 15, 2003 at 04:50:22 from (205.188.209.105):
In Reply to: 4020 pto noise posted by Kraig on August 14, 2003 at 20:43:30:
Is the distance from the drawbar pin to the end of the pto shaft correct, check the manual for your piece of equipment and see what distance it specifies. There is a different dimention for 540 and 1000 rpm operation. Is the pto shaft in line with the drawbar?What you are hearing is driveline noise carried through to the gear train of the tractor. You are either collapsing the slip yoke completely on a turn or turning the driveshaft at too severe an angle. The noise is not good for your mower or the geartrain in the tractor
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|