Tractor Talk Discussion Board |
VENEER BALER (600)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KEN HARRIS on June 28, 2003 at 19:54:00 from (199.217.187.157):
WHEN I TRY TO BALE IT RAKES THE HAY THROUGH THE TWO LARGE ROLLERS AND THROWS IT IN THE BELT AREA WHERE IT SHOULD START ROLLING INTO A BALE HOWEVER THEIT IS A METAL ROLLER THAT SETS ON TOP OF THESE TWO LARGE ROLLERS AND THE HAY FOLLOWS AROUND THAT ROLLER AND JAMS UP BETWEEN THEN IT BUILDS UP BETWEEN A BLADE THAT GUIDE THE BELTS AND THE LARGE ROLLER. I CHECKED CLEARENCE ON ONE SIDE OF THE BALER BETWEEN THE BAR IT REALLY LOOKS LIKE A BLADE AND IT WAS A HALF CLEARENCE WHEEN I CHECKED THE OTHER SIDE I COULD PULL IT A GOOD INCH AND A HALF AWAW FROM THE ROLLER I HAVE THAT CORRECTED NOW WITH A HALF INCH CLEARENCE DOES THIS BLADE NEED TO SHARPENED. BECAUSE OF THE RAIN WE HAV'NT TRIED THE BALER SINCE THESE CHANGES ANY ADVICE OUT THERETHANK YOU (KEN)
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|