Tractor Talk Discussion Board |
Re: horn-tripbucket loader,for wd or wd-45
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on February 12, 2003 at 23:27:52 from (65.237.15.28):
In Reply to: horn-tripbucket loader,for wd or wd-45 posted by frank on February 12, 2003 at 19:13:27:
When I started farming in 1972, my first loader was a Horn, on a WD. Eldon is right about the mountings, althought the front brackets are not in the "front" of the tractor- I think he means the front brackets are under the engine area, can't remember exactly which holes in the side frames, although the two brackets form a v under the tractor, between the engine and the transmission. There is a cross shaft, solid steel, which fits in the mounting brackets, and holds the cylinders. The rear mounting brackets go on the rear axle housing bolts, inside of the final drives, front side of the rear axle castings. Not the best explanation, but the bracket on the right side will be under your foot when your foot is on the footrest by the brake pedals. Left side will be near, and to the left of your foot while on the clutch pedal.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|