Tractor Talk Discussion Board |
2 stage clutches
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on February 04, 2003 at 16:07:31 from (65.165.152.137):
Some tractors with 2 stage clutches have access for adjusting the clearance between the 2 stages. Some tractors do not, but have only the pedal travel adjustment. Not being familiar with all of them, I cannot provide a comprehensive list of which do and which do not. But where there is access and there is a specified clearance between the stages, perhaps the specified clearance is not the best for your particular tractor. "Big Dean", very knowledgeable about Masseys, says that the Massey spec of 0.090 between stages may be better if set at .060, 0.050, or maybe even 0.040 after the assembly has some wear. A Long dealer says that the Long spec of 0.060 really is too much and the clutch is better at 0.030. So it may be that experimenting with the clearance and trying something smaller than specified may be worth the trouble. Makes the PTO disengage with less pedal travel.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|