Tractor Talk Discussion Board |
Re: 1948 J D starter removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on September 19, 2002 at 10:55:53 from (206.106.139.74):
In Reply to: 1948 J D starter removal posted by Andy Anderson on September 17, 2002 at 20:16:35:
Andy, my "D" experience is limited to driving one, but I'll take a stab at your question. If that "D" starter is mounted like most other Waterloo two-cylinders, in a 3 bolt flange type of affair, they can fit really tight. I would spray it with penetrating oil where the starter is mounted to the flange, and then use a rubber hammer, your hand or something similar to tap on the other end of the starter to get it moving in the flange. It should come loose for you. I would recommend a coating of grease or anti-sieze on the flange when you reinstall it, to prevent the problem in the future. Good luck with the "D".
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|