Tractor Talk Discussion Board |
Re: allis wd with v-8
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on August 13, 2002 at 03:26:53 from (24.166.248.35):
In Reply to: allis wd with v-8 posted by ryan on August 12, 2002 at 09:39:01:
Several things that have to be looked at...I have never put a v8 in a Allis, but here is the steps needed....Make up an adapter plate to bolt the engine to the tractor trans. The adaptor must be the thickness required, so the trans. shaft will reach the pilot hole in the end of the crank shaft of the v8 engine...hope the fly wheel is large enough they generaly run about 10" to 12", you will most likely have to make a new pilot bushing...the front motor mounts will have to be made up.....tighten the bolts real good and hang on......
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|