Tractor Talk Discussion Board |
350 farmall oil problem.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bill maccready on July 29, 2002 at 11:54:48 from (64.91.156.39):
Help!!. I have a 350 farmall that has just had the engine rebuilt, including the oil pump and also a new oil gauge and oil line to it. Now my engine oil pressure is low and the oil returns to the crankcase whenever the engine is shut off. This makes the dipstick reading show high whenever you check the oil. The IH dealer in my area said it is normal for the oil to return to the crankcase out of the filter when the engine is shut off,but it didn't do it before and if so,how can you check the oil level? What holds the oil in the canister type oil filter? is there a check valve some place? Any help is appreciated. Bill
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|