Tractor Talk Discussion Board |
Re: Pulling Small Stumps
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nat on July 24, 2002 at 12:06:04 from (24.28.253.50):
In Reply to: Pulling Small Stumps posted by Dan on July 23, 2002 at 17:49:08:
best thing I have used is an I beam 36" long, standing vertical, with a piece of 1/2" plate 12"X12" with a V notch cut in it with a torch, welded to bottom of beam, a cross bar of 4"X4" angle welded perpendecular 12" from bottom, and 2 pieces of 4"X3" welded 1" off center,both sides 30" from bottom for top link. just back into tree or stump and center tree in notch,lift up on lift while backing up, and tree willcome out, and will stay in notch so you can carry it to brush pile, then lower lift and drive foward. I cleared 6 acres of field pines and a plum thicket, worked great for me
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|