Tractor Talk Discussion Board |
Anyone good with hydralics and power steering?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on July 15, 2002 at 05:48:02 from (12.15.56.73):
I have a Farmall H with a mower on it that I use on the farm almost daily for various things, the steering gets a little hard by the end of the day and it is a pain to have to take it out of gear or be driving to use the hydralics. I have a Char-Lynn unit from a 450 complete with pump, I can handle mounting the torque motor in the steering shaft, and it will fit if I build new mounting plates for it. Can I use the power steering pump to run live hydralics too? Would an automotive PS pump be better for doing that? OR should I get a belt driven hydralic pump designed for hydralics and plumb the power steering into that? I use Hy-Tran for hydralic fluid anyway so that should be ok in the torque motor. Mainly looking for opinions or experience on whether or not I can do both with a single pump. I can run the pump from the crankshaft with a belt and it will work fine for the small implements I use. Thanks in advance! Steven
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|