Tractor Talk Discussion Board |
Re: Re: Synthetic Oil During Break-In ... A QUESTION !!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert Schultz on June 17, 2002 at 14:52:21 from (67.242.182.58):
In Reply to: Re: Synthetic Oil During Break-In ... A QUESTION !!! posted by Dean on June 01, 2001 at 03:09:19:
Depending on the "synthetic" oil used, it should not be used during break-in. Not just that, why would you want to dump an expensive oil just to get rid of the break-in debris but if a high quoality "true" synthetic such as AMSOIL is to be used after break-in, you should run to approximately 3000 miles before switching. Mobil One can be used sooner as it is not as slippery as AMSOIL and still allows the rings to break-in. Mobil One is factory fill in the Vette's but not for reasons that originated where some people would like you to believe. AMSOIL produces a H.P. increase when used instead of Mobil One and has been proven by Corvette Magazine with Dyno tests from Vinci Racing in Daytona Bch. Fl. For the truth about synthetics you can email me at office@aaasynthetics.com or visit my web-site at www.aaasynthetics.com Robert Schultz Lubricant Consultant Since 1984
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|