Tractor Talk Discussion Board |
Perkins Front crank seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike on May 04, 2002 at 03:54:46 from (66.81.166.12):
High , This is Mike, I have a M. F. 205 industrial with the A3-152 Perkins. I am installing the front crank seal and am having some trouble. My book says to install it 3/32" deep ,but my pully has a flange on it that protrudes about 3/16" into the housing, so it hits the seal. The seal is a double lip seal, the spring loaded lip fits the hub fine, but the dust lip is about 1/16" larger diamater than the seal serface of the hub and protrudes about 1/16" in front of the seal.Is that dust lip supposed to ride on the face of the flange or on the same surface on the hub as the spring lip? Are there two seal hub sizes, mine is 2 1/4"? The seal is perkins ,did I get the wrong seal or is my book wrong, Maybe 3/16" instead of the books 3/32". I am waiting for a reply from Big Dean , and I am interested in what you all think? Thanks again, Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|