Tractor Talk Discussion Board |
Re: Magneto Timing when engines reved?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by LynMn on April 14, 2002 at 15:22:07 from (209.23.148.30):
In Reply to: Magneto Timing when engines reved? posted by JJ on April 13, 2002 at 21:17:10:
When the mag.impulse coupling is working during starting & stoping, the spark is retarded to T.D.C. This is the clicking noise you should be hearing. About 300 RPM centrifugal force pulls in the trip pawls and you are in full advance. There is no in between. This is called lag angle. F.M. impulse are marked as to degrees Yours may be about 25 or 30 degrees. If the engine bogs with out missing a carb. tune up may help. However dont over look the spark plugs on these engines that idle a lot.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|