Tractor Talk Discussion Board |
Re: Fence installing?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on March 12, 2002 at 14:34:47 from (216.209.117.7):
In Reply to: Fence installing? posted by Rod MI on March 11, 2002 at 08:45:48:
In some municipalities/counties some public service jobs are for "fence viewer". This guy's job is to settle disputes and as an advisor on putting up fences. He gets a small fee for his services but it's not much. If this is your case have him come over before you strike off the line and tell him your plan. He'll give you some pointers. I did the same thing cept my fence line was all grown in with briars. So I ran a line 80ft out from each corner stake. That brought me out in my hay field. It was a 640ft stretch so I can site rite down to the end. I then sited along a line of T rails I painted neon yellow. When I was done with that I measured in 80ft in from every post to give me my property line. I figure the degree of error is about 5inches which is good enough for me and I doubt the county will spend court costs for 5inches.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|