Posted by rrlund on March 14, 2023 at 10:01:15 from (173.225.203.221):
Does anybody know how those Thermo Start manifold heaters work? Does something open up inside them and let the fuel in when they reach a certain temperature or something? There's no wire to the little fuel reservoir, there's fuel to the nozzle/heater unit all the time.
I had one quit working three weeks or so ago, so I ordered a new one. Meanwhile, I discovered the old one popped (ignited) after 30 seconds or so. It used to after about 15 seconds. The new one got here, so I went ahead and put it in, figuring it would pop after 15 seconds or so like it used to. It didn't. In fact, in the two weeks or so since I put it in, I've only heard it pop once, and that was after 30 seconds or more.
It's been relatively warm, so I've just been holding it for 30 seconds and it been starting. I figure it must have just been getting enough heat from the electrical coil to give it the little help it needed. This morning it was 16 degrees. I finally got the tractor started, but it took a while. I felt the unit and about burned my finger from the electrical coil being so hot, but it never popped. I've had the T off, blew through it, blew air up the fuel hose all the way to the tank, and still no pop.
I'd put the old one back in and try it again, but the old one had a spade fitting for the wire and the new one has a screw, so I had to cut it off and put a new one on it for the screw. I don't have any new spades that big. I'd have to go to town and get one. I hate to keep cutting that wire back, it's none too long now. I could clamp it with Vice Grips I suppose, but I'm not going to run it that way.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
