Posted by MNHunter01 on November 22, 2022 at 14:26:35 from (165.225.10.174):
New owner of a 1970 Ford 4400 gas. The tractor was having fuel issues when I picked it up. Runs well for a few seconds (occasional minutes) and then just quits. Always restarts without issue, but same failure occurs. Its starving of gas.
Digging into it now and I can see that the fuel setup between the fuel tap to holley carb has been overhauled in a frankenstein manner. The mechanical pump has been replaced with an electric pump. Some of the existing metal lines are still used and in between those metal lines is rubber lines. The sediment bowl is gone, but a brass fuel filter exists.
When I went to work on the tractor I discovered the pump was not getting fuel. Blowing backward in the line to the tank cleared a blockage and then the pump worked as I'd expect, however in messing around, the metal line feeding the carb pulled out of the carb fitting. I am struggling to get it back in...My question is, can I replace all lines with rubber?
That would mean replace the fuel port on the carb to accept a rubber line and hose clamp over the top. Thoughts? I will also be cleaning out the gas tank and ideally replace the fuel tap with something with a filter. If I can't get at it, Id prob shop vac out the tank to pull the garbage... but not sure if it will be effective.
fuel setup plan would be: New fuel tap > Rubber line > new in line fuel filter > Existing Electric pump > New fuel line directly to carb port
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
