Posted by Christopher S. on October 03, 2022 at 07:06:43 from (24.154.25.70):
Good Morning, the pole building we store our tractors in has (6) 12' wide x 14' high doors. Three of them are located on the back of the building and three of them are located on the front, this allows for a pull through situation. The building is about 8 years old now. Over the last year or so the (3) garage doors on the front of the building get stuck. When you un latch the manual slide latch the doors will not move up. If you push down and jiggle the door on the side opposite of the latch it will sometimes free itself and start going right up. Once the doors have been operated once that day, they go up and down without issue all day long. Once you latch them for the night they will be stuck the next morning. We have been up and down extension ladders many times trying to see the problem but can not come up with anything. We thought they were getting stuck under the header but that is not occurring. We put a spacer under the track where it attaches to the door frame thinking it was jamming but that did not solve anything. The tension on these front doors is a bit strong so that they go up to give the full 14' of opening. There is a slight grade coming into these doors and it allows for proper clearances. Could latching only one side of the door at night be allowing door to bind/rack with the extra tension? Thanks for the input.
This post was edited by Christopher S. on 10/03/2022 at 07:18 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
