I used a 6 ft Brillion rotary cutter to mow hay for several years, neighbor we baled with tried it first. The right side of the Brillion bolted on, easy to take off, He had Dad cut the diagonal piece off behind that right side panel with the torch and weld on angle iron to bolt that piece back on to chop corn stalks. I could mow 20 acres with our 6 ft Brillion in 5-6 hours running in 3rd gear with my Super H. The Brillion was a cheaper cutter, pto shaft only had TWO universal joints, one right by the gearbox, other right by the tractors pto shaft. If you tried to turn too sharp the driveshaft hammered REALLY bad. I also chopped 100 acres of corn stalks late every fall after the corn was picked. A sickle bar mower would be the easiest pulling mower but could cause the most plugging if not maintained well. An M could easily pull a 9 ft sickle mower in 4th gear, 5 mph. A guy posts videos of compact tractors working, named Tractor Time with Tim, He uses a RHINO TS10 rotary cutter behind a tractor about the same HP as your M and he mows some tall weeds/grass and does a really good job mowing, no skips, no streaks, no big bunches of clippings. I'm sure that Rhino mower would be your most expensive mower option.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.