Posted by Leon R on May 23, 2022 at 13:04:27 from (96.50.232.160):
I semi retired my MF65 gas after 42 years of hobby farm use and replaced it with a new MX6000 mainly because I am creeping up there in age (79) and wanted power steering, faster hydraulics and getting rid of the clutch. The Kubota fit the bill in those areas. What I liked about the 65 that the Kubota does not have is the hand crank adjustment of the three point Hitch that I could reach by leaning over the back of the tractor without getting off. To adjust the Kubota you need to get off and awkwardly adjust the tilt by wrestling with a square tube type adjustment. The MF65 also had ground speed PTO which the Kubota does not have probably because of the HST. I also don't think these tractors were designed for a 6'1" 185lb operator with normal leg length and size 13 work boots. What I find a little awkward is the HST control when backing up and twisted in the seat looking back. That also raises the problem of the seat and steering wheel position. To comfortably operate the HST pedal my knees should be at least parallel to my hips rather that above them. When I added a couple of inches to the seat to accomplish that my legs get in the way of the steering wheel when I turn in the seat. To fix that problem an adjustable tilt steering wheel would be nice. Overall I am happy with the Kubota but they could maybe accommodate us taller guys with a few improvements.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.