thankyou both caterpillar guy and danofarming for your replies. That got my dad to chuckle quite a bit. The ugly welds on the drawbar occured in the 1930s when the L was used to pull a breaking plow to clear land. The Case was driven in second gear and would routinely get caught on stumps and brush. Plowing is much faster then digging, pulling or blasting small stumps out. So the tractor was driven wide open in second gear to keep up inertia and momentum for plowing under oak, maple, ash, alder, and fir tree stumps. the rule of thumb was that the Case could turn under any stump of 4 inches or less. Many times, stumps would require multiple attempts at the same stump, but many acres were turned under in amazing speed compared to years of grazing, burning, pulling, and turning hogs out into the fields to root out the stumps. Just keep ramming them with the poor L and keep welding er back up. The breaking plow was also the reason to the higher hitch point welded onto the rear channel iron, both for more clearance under plow hitch and also for more traction on the 28 rear tires with concrete poured to fill in the wheel spokes.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.