Posted by Janicholson on September 01, 2021 at 14:56:20 from (24.240.46.228):
In Reply to: Regulator adjustments posted by LarryV1 on September 01, 2021 at 13:10:04:
Assuming a mechanical voltage regulator, yes. There are (two or three relays under the cover) one will be a cutout relay with heavy wire around it. and two more one with both fine and heavy and one with fine only. If only 2, there will be one with heavy and one with fine wire. Adjust the tension on the relay with fine wire only. It will be the voltage control it works by vibrating the contacts causing the field to get pulsing DC. The timing and on state of the pulses control the amount of field current being made, and thus the output voltage. Id the spring holding the contacts closed is just a bit too tight, the generator over charges. The amount of change to adjust is very small. Some have a screw that is used, and some just have a tab that anchors the spring that is bent to adjust. Make sure the battery is fully charged prior to adjustment. This allows an accurate voltage setting. The cover will also affect the output as the cover changes the magnetism in the towers unpredictably. so before assuming success put the cover on and recheck. I have described the adjustment as though it was simple. It is delicate, and can be complex. Finding a Motors Manual from the late 50s will help understand what is going on. Reading is your friend. Libraries have copies and photo copying them is a real possible solution. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
