Thanks for replies, much appreciated. It is good to finally find an active forum for Red Iron. Re TA I dunno I have read about a lot of issues with em, mine doesn't have it, came factory that way and yes the tractor is a bear to shift most of the time, trans brake is obviously worn-out, and speed shift linkage/fork? is certainly not ideal, but it works, sometimes it'll have a tizzy...
On the 3pt hitch, the crank arms are extremely loose where they connect with the torsion tube esp the side where the torsion bar connects to the frame, feels as though the crank arm splines are worn out, (I have the bottom hitch assembly and crank arms off at the moment), the torsion tube splines seem ok although difficult to know for sure. Is it (un)wise to replace the crank arms only w/o replacing the torsion tube, seems as though these oughta be replaced at the same time? Replacing the torsion tube means pulling the IPTO, new seals/bushings and as I understand it a rather serious effort to get the torsion bar pressed out of the torsion tube which I'd like to avoid if possible.
Also, is it normal to be able to hand rotate the rock shaft (using the upper control arms as leverage) to the full upright position?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.