Pulling a 45' paddle elevator down a country road. JD G going flat out at about 13. The elevator was balanced perfectly on its 2 wheels. we were going down a slight incline and the pin in the clevis came out. The front gently came up about seat height. There was zero possible speed increase available as the slope was no steep enough to coast faster. the elevator hung there like a battering ram for 5 seconds (an eternity) then started catching up. I had been running with the right elevator wheel next to the grass. The crown of the road influenced that wheel to slow a tiny bit. The front of the elevator gently moved to the right away from my back, and the tire started into the grass. That slowed it more, and it swung right over the tire and toward the ditch. There was some terrible noise and ripping as the elevator got caught in a barb wire fence. It took out 5 fence T posts, and ripped wire off of 8 posts up hill from the impact. The fence was being used to contain 20 heifers, so we were obliged to make haste with repair and triage. Our follow car was used to go get a chain and fence posts, wire, clips, and a post driver. We pulled and untangled the elevator (which was unscathed) back into the road and attached it with a bolt/nut!! The next 2 hours were spent making the fence better than it was. The farmer who's fence it was came home as we finished. and was impressed with our cleaning of the fence row and restringing it with new posts. When we told him what happened all eh said was was there a lesson here? We said there was. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.