Basic operation. The TA is a gear reduction unit that is between the engine clutch and the transmission input. The TA gears are housed in a carrier that spins with the engine clutch in direct drive, and is stopped when in gear reduction. the TA front clutch is a hydraulic multi disc clutch that is under pressure and locked up when in direct drive. This causes the engine to spin the TA gears and housing as a unit, transfering engine RPM to the transmission. There is a one way (overrunning clutch) at the rear of the TA when in direct, this clutch is slipping in its CW direction (looking from the front of the tractor)as it should. When the lever is moved to reduction (back) the front TA clutch is no longer pressurized, and is free to rotate. The gear reduction in the TA carrier now tries to rotate the TA assembly CCW, but the one way clutch locks it to the case of the main TA housing and stops that from occurring. The gears now rotate the trans input shaft CW but in reduction through the TA gears. There is also a small multi disc clutch at the location of the one way clutch. This clutch is applied when the TA lever is in reduction. it is not a strong brute of a clutch. its only job is to prevent the one way clutch from turning in its free direction. This is so the tractor does not coast down hills and overspeed from that coasting. costing loss of control. It is not designed to be downshifted into TA reduction as a braking action and will wear out if used that way. So it is best to use the TA while under pulling load, and never to slow down on the road. I hope this makes sense. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.