If you have other rural households in the area, USDA Rural Development may be able to assist you all in development of a rural water system. Talk to both of the above resources, I'm sure there are programs out there to help you. Start with the state first, they know how to get the feds involved.
You, as an individual, probably can't tap into public funds. But a group of people with similar problems/issues can form a non-profit and get things done. Talk to farmers & ranchers in the area, too. I wish I was closer, this is exactly what I did for a living for 32 years. I helped folks with problems just like you are describing solve them.
One of the groups that I worked with ended up with a rural water system with a million dollar well that was just under 4,000 feet deep. It would produce 160 gallons per minute. There were 13 household and 8 pasture taps (21 taps total), a 121,000 gallon storage tank on 109 miles of pipeline. Average monthly cost per user was $75.00 per tap per month, plus $2.00/1,000 gallons used after the first 2,000 gallons. Initial hookup fee was $1,500 (I think). That was back in 2009/2010, so I'm not sure what the rates would be now. The base monthly tap fee was set up to pay amortization of the loan needed to match the grants they got to build much of the system.
That particular system had the highest %age of grant of any project that I ever worked on. Given the current circumstances, I doubt if there is much grant money around, but there might be a lot of grant $ available in the neat future. Remember, this was at an opportune time because there was infrastructure grant money that became available in an effort to boost the economy. Remember the 2008 recession?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.