Posted by Dirtsmith on November 13, 2020 at 01:25:43 from (174.54.45.13):
If I can find a rusted out no good bucket that will fit my loader, I am thinking it should be possible to convert what is left of the bucket into a frame for a set of forks.
There are forks that can be to attached to a bucket, but I just dont like them. I they project too far out in front of the tractor, and despite have rear wheels full of weights, a full bucket already can bring the back end up enough to not make good ground contact. Extending something another three feet in front of the bucket just has no appeal.
I dont have a rusted-out bucket yet, I am still looking for that, but in the meantime, have any of you done this or something like this before?
This project will require me to do some out-sourcing; I have no welding equipment (or experience) and am certain even Duct Tape would be outmatched with this job.
Despite my current obstacles (no bucket, no experience, no clue) this still seems like a project worth pursuing as forks would be really helpful for me.
If you have insight into a project like this, please tell of your experiences. I am not above learning from anyone else.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.