Posted by 8NChris on September 15, 2020 at 20:59:49 from (172.58.142.174):
In Reply to: Gas vs diesel posted by svcummins on September 15, 2020 at 16:25:59:
When I was employed at Dallas Peterbilt and Masters International it was not uncommon to see an over the road truck with a million miles on it. As an auto tech I have seen few gas engines with over 300,000 miles that have not been opened up at some point. They were Ford and Chevrolet pickup trucks. Normally Cummins with over 700,000 miles were running fine as the Dodge deteriorated around it. About the same with 7.3 PowerStroke.
Concerns over starting cold have been explained well enough. One thing to consider is some research Continental Engines has done. What they found is that the colder the operating temperature the greater the cylinder wear. For the 15-20 minutes it takes for a diesel to reach it's operating temp I personally would plug mine in, at least in the winter. That is a practice I followed when I owned a 7.3. When I worked on the fracking trucks I would have to idle them around the yard still hooked up and in 3rd for about 7 to 8 minutes to get them to operating temperature. If the work order came in early enough I would let them idle for 30 minutes. Still wouldn't be warmed up but it cut the drive time down to a couple of minutes before it was.
The cylinder wear is not limited to any fuel type.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.