Posted by JerryCPP(WA) on December 30, 2019 at 19:25:24 from (66.172.99.31):
I just got a very old Komatsu PC05 mini excavator. It had a new thumb installed before I got it. They got pressure for the thumb by cutting and welding a cap on the ¾” pipe return line, taking pressure from that line, running it to the thumb valve with 3/8” hose, and back to the filter and tank, effectively making the main return line 3/8” hose. I don’t think restricting the return line is good. I want to put a T in the main pressure line (manual says main line max is 2489 pounds,) install a Prince R1850H relief valve in the new line, set it to 1000 pounds, and run that hose to the thumb valve. Then when you activate the thumb, it will only get 1000 pounds pressure. When you curl the bucket, the thumb cylinder will over-pressurize, causing the Prince valve to relieve pressure to 1000 pounds, with the blown-off oil going back to the tank. I will restore the original main return line to ¾”. Am I off base here? Suggestions?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.