Posted by tomstractorsandtoys on December 20, 2019 at 17:19:58 from (50.123.236.82):
In Reply to: Jd 1520 no till drill posted by spitz on December 20, 2019 at 16:46:13:
The problem with drilling soybeans with a drill is that a drill is just a controlled spill. You just can not get good seed spacing and seed placement with a drill. Here (WI) the farmers that were using drills have all went to 30 inch planters. Neighbor simply plants his beans between the existing corn rows and gets great stands. We split rows for a few years to get 15 inch but several neighbors had plots that showed no advantage to rows less than 30 inches. Very few drills are going to do a good enough job planting into the residue from 180-200 bu corn. Planters can be set up with row cleaners to do the job and do it well. We have a Deere 7000 setup with combo no-till coulters and row cleaners. Our beans ran 70.5 bu to the acre across the scales this fall. Tom
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.