Posted by BushogPapa on May 01, 2019 at 06:56:23 from (24.208.167.12):
In Reply to: Plowing questions posted by Grandpa love on May 01, 2019 at 04:31:14:
By the looks of it, I think there are several possibilities...
The signs of wheel slippage may indicate you have too much plow for the tractor (but maybe more weight can help..if you have enough HP)..
2nd, Adjustments could be your problem, but I suspect worn-out Shares are not sucking the plow down like they should..
Moldboard Extensions A
Always help Roll the slice over better and Cover-Boards always make for a cleaner job of covering residue...
A 4" or 4 1/2" Angle Grinder ( Wear a dust mask and safety glasses) and Thin "Cut-Off" Discs will clean the rust rather easily.
Just hold the thin disc at a shallow angle to the Moldboards ( etc) and move it as if it were a Putty knife scraper..
It will NOT mark the surface, but WILL remove the rust, leaving a smooth Black oxide coating that WILL Scour right away...
Now...NEVER EVER allow your plow to rust again..!!
I prefer to smear grease over the wearing surfaces, but have good results with a coat of used engine oil and a good coat of Cheap Enamel paint over the oil to hold the oil in place.. Either way, it scours right off and you are in Business right away..!!
New Shares are sometimes a Necessity and the eventually do wear out.. Ron..
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.