Hey, Guys. Sorry it took me a week to get back at it. Thanks for all the helpful suggestions, so far. All useful stuff to know whether it winds up being the fix or not.
With the fuel turned on, the carburetor is dripping fuel from the little screw at the very bottom. Not on purpose. I hadn't loosened any thing. When I tighten the screw, it still drips. The fuel may be coming from somewhere else, and this just happens to be the low spot that it drips off. There is a "wet look" that extends part way up the carburetor with the high spot being the choke. Is it possible to have some sort of capillary action where the fuel is traveling up through the grime, or is it likely leaking from the highest point that looks wet?
Another thing I noticed was that when I loosened the screw, it only comes out so far--you can't take it all the way out. Is that how it's supposed to be? It screws into what looks like a little red nut or bolt head at the bottom of the carburetor. This nut/bolt head looking guy has some sort of sealer between it and the rest of the carburetor. Is it cool to unscrew this guy? It may be where the leak is coming from.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
