Posted by 2510Paul on February 06, 2019 at 04:44:50 from (72.160.248.225):
In Reply to: Re: Gas line measurement posted by Roger Tomfohrde on February 05, 2019 at 15:30:10:
Hi Roger. I can tell you really know this stuff. I have a detached garage and the meter/regulator is behind the garage. The Gas Company told me they regulate in WI to 2 PSI beyond the meter. It is 68' from the meter to the house, 1/2 inch of that csst (I think from what has been said on this post). At the house it is connected to 3/4" steel pipe and goes inside for about 15-20' to the furnace.
Yesterday I talked to the Owner of the Dealership, he is coming today. But he pointed out the 2 PSI has to be regulated down at the furnace to 3-5" W.C. and there should another regulator. Yup, there it was up in the floor joists kinda partially tucked above one of the ducts. I never saw it. So I have the right guy coming today.
Yes, we will have discussion about the 1/2" but he is not the one that gave it to me to bury. A prior dealer gave me that 1/2" pipe to bury when I switched to Natural Gas. That prior dealer did all the terminations at both ends. I depended on him to know what he was doing.
The saga continues but at least my furnace has not tripped out since the Stupid Cold (one weather forecasters term) weather left. I keep leaning and now the Owner of the Dealership I currently work with can come and inspect.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
