I have a 210gal indirect storage tank hooked to my wood fired boiler via a water to water heat exchanger in the tank. The tank also supplies domestic hot water during the heating season. When heat is called for the hot boiler water is pumped to all the circuits calling for heat and also the storage tank is heated utilizing a separate zone circulator pump. All zones controlled by thermostats, except for the storage tank circuit. It is live at all times that there is power to the boiler. My boiler is not a gasifier, but does utilize a combustion fan which is turned on and off with a temp sensor switch. It turns off combustion air fan at 180F boiler temp and back on at 165F In my boiler, the fire can survive without the fan running as apposed to a gasifier and my smoke goes up the chimney rather than entering the gasification chamber where it burns at 1200F. There is a lot of heat left in regular smoke, which makes gasifiers so efficient. With my system, I had to put a jumper into one of my heating circuits also so that pump now runs continually. It can get a little warm in that room, but Wwth no heat called for the boiler could over heat and pop off the P&T valves in the system. The storage tank works like a battery to stabilize the water temp, but I still have to keep an educated eye on all the components and temps at the distribution manifold. Gasifiers effectively shut down the burning process when no heat is called for, similar to pellet stoves, which also adds to their efficiency. I hope that I did not confuse you more. Loren Loren
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
