Posted by Dean Ray on October 24, 2018 at 22:54:10 from (98.212.124.172):
In Reply to: hupp D59-2 posted by Dean Ray on October 24, 2018 at 12:37:46:
I want to thank you for responding to my post. I rebuilt the tranny in the old ferguson. I was really surprised on how all the shafts and gears were in good shape.The tractor wasent taken care of before I got it...No maint. at all. I cleaned every thing up good repaced all the bearings with timkens...I knew what the hupp did but didn't know they were add on's. Nothing in the repaire manual about them..I carefully took it apart marked everything...Cleaned the shafts and replaced the bearings in the idler shaft put it together eveything good. put the gears in and the shifter forks tried it out..would not shift kept hanging up..First thing i thought the other owner took it apart and left somthing out..I knew it was apart befor becouse no gaskets just blue junk.So i thought i was going to need a book to se if the did..I already knew no one around here knew what a hupp was....I got lucky and found a on line tractor book that you could just view and found a hupp digram on how to install hupps on fergusons. Showed all the parts---nothing missing...I said to myself rut-ro and started putting it togeather ...the forks went on the shaft harder than they should ...the balls in the shifter forks looked very bad tryed lub didnt work---i have the fork and springs i solvent and orderd new ball...i let you kow what happens
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
