Posted by fpappal on October 22, 2018 at 18:27:46 from (24.59.216.172):
I bought a new tiller shaft and bearings for my Troy-bilt horse. I accidentally scored the shaft while replacing an oil seal. I bought an aftermarket shaft on ebay (made in USA) and it is the exact same size as my old shaft. I also bought new bearings from Autozone using the numbers stamped into the old bearings. The new bearings do not fit tight on the new shaft, there is just enough slop where the bearing spins. I was told to use Loctite bearing mount #8531. Looks like that product is discontinued. A quick google search leads me to Loctite bearing mount #680. I have never had a bearing that didn't fit tight on the shaft so this is all new to me. Does anyone know if this Loctite product is the answer to my loose bearing? I am only looking at a few thousandths at the most to make this bearing fit tight on the shaft. Any suggestions are appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.