Posted by jimg.allentown on September 01, 2018 at 07:39:24 from (108.16.40.107):
In Reply to: Re: engine rebuilding? posted by gene bender on September 01, 2018 at 06:18:02:
If you use oversize bearings, your engine will most certainly knock - and loudly! In order to standardize nomenclature, certain standard means of describing parts have been implemented for as far back as engines have been built. The size of the bearing refers to the INSIDE DIAMETER of that bearing. NOT the thickness of that bearing. Crankshafts that have been reground to a standard undersize require undersized bearings. That is why there is a standard in describing them. There have been uses of oversized bearings in applications where the inside of the connecting rod has been machined to a larger diameter.
Supposing you were rebuilding an engine, and you needed replacement bearings, the parts man would ask you if you want standard or undersized bearings. Don't take my word for it. See for yourself. Better yet, pick up an old Motor's repair manual and read it for yourself.
We can argue about this for as long as you like, but you will find that it will be a small minority that call bearings oversize and the majority will call them as they are - UNDERsize.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.