Posted by ptfarmer on August 07, 2017 at 01:15:01 from (70.114.32.211):
In Reply to: Welding on tractor posted by craig45 on August 06, 2017 at 17:19:24:
No matter what you are still putting current to any electrical devices on the tractor wither the battery is hooked up or not. The only 100% way to protect a electrical system is to remove every bit of it before welding. If you are welding on a implement, and if you are worried about damaging anything on the tractors electrical system just unhook it from the tractor. I have welded on a lot of things over years that have electrical components on them, and never unhooked the battery. Never experienced a electrical problem afterwards, I just hook the ground from the welder as close as possible to where I am welding especially if there is a bearing close by. Having a bearing between the ground, and electrode is never good for any bearing. I've seen bearing(s) that were badly damaged due to welding where the current was passed through bearing(s). If something electrical goes bad chances are it was on its way out anyways even if you didn't do any welding.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.