Posted by Jeff nwoh on July 23, 2017 at 17:31:06 from (107.11.4.77):
I posted a while back about my offset flail mower I bought on the cheap at an auction. I really needed it centered so I can haul it on my trailer. I had the week off work so I spent a couple afternoons on it.
I cut all the mounts off and shifted the 3 point and gearbox assy around 20". I then extended the driveshaft tube. I didn't have a long enough scrap of 2.5" pipe to make it in one piece, so it has a splice. I figured I didn't have anything to lose by trying to stretch the driveshaft, so I went for it. Solid piece of 1.5" with a 1.125" hole bored in each end about 2" deep. I then cut the original in 2 and pressed it all together and welded. It only has a few thousandths runout so should be fine. Making the tube and driveshaft saved me around $350.
I have a couple bearings for the rear roller and a new set of knives on order. I may even blast it and paint it. Should make a nice mower now that I can haul it without leaving a trail of broken mailboxes behind me.
I don't remember who suggested Montage for the parts, but I thought they were reasonable. Even gave me free shipping.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.